Before I could pour resin I had to make
sure I had created the molds.
Creating a resin mold:
I did this by placing all 3 of my objects
onto the vacuum forming bed; I placed them onto of the polystyrene and pushed
the vacuum form bed up to then create the actual mold. Each of my three objects
molded well and I was able to get each of them out without having to struggle
and break the polystyrene. Then using wire I bent them into the molds and stuck
them in place using masking tape. The wire was used so that they could by
placed into a frame later on.
No comments:
Post a Comment